[79FT]: Building Things
Fixed mis-alignment in ailerons
|On:||May 21, 2014|
|Tags:||CAD, lower wings, ailerons|
Today, got only about an hour and a half for CADing. Re-opened my Lower Wing model, 50% thru or so, and started remembering things and checking things around.
I was right at a point when I hung the ailerons on the wings, and this time was re-checking the alignment again, only to find that they were off! Looked like they were lower than the rest of the wing ribs, by about 1/16th. Clearly visible on the screenshot below.
Black lines are aileron outline, orange lines are wing ribs
Started digging around and re-checking the hinges, holes, etc, with plans. The 'spar' side hinges are the most complex ones, and they were fine.. When checking the aileron assembly though, noticed this, which struck me as odd (and a bit illogical):
Aileron hinge sticking a bit 'above' the spar
Notice it sticking up? 3/32nds! Close to 1/16th. Arguably, there will be the filler there, but it still seems illogical (yes, mr Spock? :) ).
Anyways, moving the spar attach holes on the hinge up by 1/16ths (plans call for 3/8ths between the top of the hinge and the top hole center), so 5/16ths it is. That moved the whole aileron up on the hinge, and therefore, relative to the wing, and voila - a perfect match!
Yay! A perfect match.
Now, I know that in reality I will be drilling holes in spars in place based on the pilots in the hinges (or the other way around, hinges based on holes in spars (damn.. Im yet to decide.. :) ); but I'd rather start 'clean'.
Better to be on the ground wishing to be in the air than in the air wishing to be on the ground.
© Copyright "79FT". All rights reserved. Feel free to cite, but link back to the pages cited.
This website only shows how I did things in my various projects. These pages are for information and personal entertainment only and not to be construed as the only way, or even the perceived correct way of doing things. You are responsible for your own safety and techniques.