N79FT A Skybolt Story

Lower Wing Fittings and Torque Tube


On: Jun 16, 2014
In: fuselage
Tags: CAD, fuselage, torque tube, control system, ailerons, elevator, lower wings, fittings

For starters, cleaned up the torque tube; added all the hardware (thanks cwilliamrose again for AN hardware models!) and proper mates. Was a nice warm-up, and came out real well.

Torque Tube, Cleaned Up with HW

Torque Tube, Cleaned Up with HW

After that, added the lower wing front fittings to the fuse. Piece of cake! :)

Lower wing front and gear rear fittings

Lower wing front and gear rear fittings

... and zoomed in.

... and zoomed in.

Notice on the above picture how they interfere with the tubes of the fuse truss (geometry penetrates one another). There are a couple ways to fix that; plans just call for 'trimming in place'. Note to self: figure out if the weld should only be around the bottom longeron; or if to weld the top of the fitting to the vertical too?

The cool thing about SW is that I can "cut" in place; add a bit of margin on the real pattern for the fitting, and make it to fit without constant trial and error.

And then, lower wing rear fitting.. that one is tricky due to the way it's dimensioned on the plans (it makes sense plan-wise, since it maintains clearances between longerons and spar butts, etc; so hole positioning takes metal thickness into the account). Can't believe it took me 2 hours and a few tries to figure out how to model this right. Learning curves be damned :)

Lower wing rear fitting

Lower wing rear fitting

Now, the reason for all that trouble is that getting the flat pattern out of that is just 1 mouse click!

Lower wing rear fitting

Lower wing rear fitting

I think this was a great day. :)


Up ↑

Powered by B-Log, which is based on Pelican, heavily plugged and themed.

© Copyright 2014-2015 "N79FT". All rights reserved.

This construction log only shows how I did things during the construction of my Skybolt. These pages are for information and personal entertainment only and not to be construed as the only way, or even the perceived correct way of doing things. You are responsible for your own construction techniques.